Cleanup - Graco 2300 Hi-Boy Operation, Parts

Cleanup

1. Perform Pressure Relief Procedure,
page 10.
2. Remove tip guard and Spray Tip. For
additional information, see separate gun
manual.
ti25832a
3. Remove fluid intake and drain tube from
paint, wipe excess paint off outside.
334827A
4. Place fluid intake in flushing fluid. Use
water for water base paint and mineral
spirits for oil-based paint. Place drain
tube in waste pail.
5. Turn prime valve horizontal.
6. Increase pressure 1/2 turn to start motor.
Hold gun against paint pail. Disengage
trigger lock. Trigger gun and increase
pressure until the pump runs steady and
flushing fluid appears.
7. Stop triggering gun. Move gun to waste
pail, hold gun against pail, trigger gun to
thoroughly flush system.
ti24709a
Operation
ti24710a
ti25874a
19