Answering a Call
1. Pick up the corded handset to answer the call in Handset mode, -OR-
2. Press the speaker button to answer the call in speakerphone mode, -OR-
3. Press the corresponding line button to answer the call in speakerphone mode, -OR-
4. Press the headset button to answer the call in headset mode.
set button (in headset mode) to end the call.
NOTE: Adjust the volume by pressing the vol (- or +) button during a call.
Receiving a Cellular Call
similar to lines 1 and 2. To answer the call:
1. Pick up the handset from the base cradle. - OR -
Press the Speaker button on the base. - OR -
Press the Cell button on the base. -OR-
Press the Headset button on the base. (if a wired headset is connected to the base)
Switching Between the Speakerphone, Handset, and Headset Mode
To switch to the speakerphone, press Speaker button. The speakerphone indicator will illuminate. Place the
handset back into the cradle.
T
switch to the headset, press the Headset button to enable the headset. The headset indicator will illuminate.
Mute
you, but you can still hear them.
1. Press Mute button to activate the mute feature.
NOTE: When using the mute feature on the base, the indicator will illuminate when the mute is
activated.
2. Press the Mute button again to de-activate.
Do Not Disturb
This feature is set at individual telephones to disable (silence) an incoming ring signal. When there is an
incoming call , the status indicators will function, but the phone will not ring.
1. When the unit is idle, press the DND button.
2. Use the VOL (- or +) button to select the duration. You may choose from 15 minutes, 30 minutes, 45 minutes,
1 hour, or 2 hours and increase the duration by 1-hour intervals up to 24 hours.
3. Press the SELECT
lowed by the length of time in hours and minutes that the ringer will be disabled. Additionally, the DND
5. To cancel, press DND button again.
Speaker button (in speakerphone mode) or Head-
ell
-
18