With Satellite Receiver - RCA RBA29550 User Manual

Using Your TV and Remote
With a Satellite Receiver: Basic Operation
You may also be able to use the TV's remote with the RCA DSS
satellite receivers. Refer to your Satellite Receiver owner's manual to hook up
your Satellite Receiver. The remote may need to be programmed for other
brands of satellite receivers, but may not operate all models of the brands
listed below. Use the codes below or on the sheet packed in with your remote.
Follow the instructions below for basic operation of your receiver. You
may also want to experiment with other buttons on the remote to see if
they work with your receiver.
Program the remote for your
Satellite Receiver
Turn on the Satellite
Receiver
Turn off the Satellite
Receiver
Satellite Receiver Codes
Chaparral ..........................80,81
Cheyenne ...............................81
Drake .................................82,83
DSS..........................................00
GE............................................00
General Instruments...92,93,94
ProScan...................................00
RCA.........................................00
Realistic ..................................84
Sierra I,II,III............................81
STS1.........................................85
STS2.........................................86
STS3.........................................87
STS4.........................................88
Toshiba ...................................89
Uniden....................................90
Video Cipher II......................91
REW PLAY
REC STOP
DISPLAY
MUTE
1 2 3
4 5 6
7 8 9
INPUT
0
•
CLEAR
MOVE
®
DSS is a trademark of DIRECT TV, Inc., a unit of GM Hughes Electronics.
®
A. Point the remote at the satellite
receiver and hold SAT•CABLE.
B. Enter the code for your brand
from the code list below.
C. Release SAT•CABLE.
D. Press POWER. If nothing
FF
happens, try pressing
SAT•CABLE and then POWER.
PAUSE
SKIP
A. Press SAT•CABLE to set the
remote to control the satellite
receiver.
B. Press POWER to turn on the
receiver if it did not turn on
PREV CH
when you pressed SAT•CABLE.
A. Press SAT•CABLE to set the
remote to control the satellite
ANTENNA
receiver.
B. Press POWER to turn off the
RESET
receiver.
11