Table of Contents
Advertisement
Setup and Connections
The Basic connection
The basic connection below (TV and VCR) is the most common
connection and is therefore used to illustrate a single component
connection with your TV. For better sound and picture quality and
multiple component connection information refer to the next section,
Advanced Connections.
Cables
You will use the following type of cable to make your connection:
Coaxial Cables: In this connection, two Coaxial
Cables are used: one connects from an antenna,
cable, or cable box to the VCR, and one connects
from the VCR to the TV. These cables carry both
audio and video signals.
CABLE, CABLE BOX, OR ANTENNA
CABLE, CABLE BOX, OR ANTENNA
VCR 1
OUT
VIDEO
AUDIO
TV
VIDEO
R
R
VCR
CONTROL
Once you have completed this connection you may skip to Step 3,
"Connect the IR Controller."
IN FROM ANT
CH3
CH4
OUT TO TV
AUDIO
L / MONO
IN
L
OUT
CABLE/
ANTENNA
S-VIDEO
How to View the VCR
To watch the VCR in this connection tune TV to
Channel 3 or 4.
Later, in the Interactive Setup section you will
program the TV to automatically tune to Channel 3 or
4 when you turn on the VCR.
Please note that models F25625 and
F27625 do not include an S-Video jack or
Audio Output jacks.
5
Advertisement
Table of Contents
