Digital Connection; Connecting Antennas - RCA RTDVD1 User Manual

Digital Connections
If you have a SAT receiver DVD player or CD player with a
digital output, you can make use of an optical digital con-
necting cord (not supplied) or coaxial digital connecting
cord (not supplied) to carry the audio portion of the signal
and enjoy Dolby Digital or digital stereo sound quality. One
optical or coaxial cable is needed for each SAT receiver,
DVD player or CD player. When optical or coaxial cable is
used, the analog audio cables are still needed if recording
through a tape or VCR is desired. This receiver provides one
optical and one coaxial digital input for the connection of
your components. Please connect your components (e.g.
DVD, SAT or CD) to the appropriate digital inputs and
select the appropriate source (see below).
NOTE
Optical and coaxial cables carry only the audio
portion of the signal. A video connection must also
be established by connecting a video cable to the
(SAT) video input.
Read instructions carefully when connecting components to
the receiver.
Digital In Jacks can accept Dolby Digital (AC-3), or PCM sig-
nals when compatible components are connected.
OPTICAL DIGITAL IN (AUDIO)
Optical Fiber Cable
Connect to optical digital output of DVD, CD,
SAT or other compatible devices.
SAT / DVD / CD Player
SAT
COAXIAL DIGITAL IN (AUDIO)
Connect to coaxial digital output
of DVD, CD, SAT or other
compatible devices.
SAT / DVD / CD
S P E A K E R S
Manufactured under licence from Dolby Laboratories.
"Dolby", "Pro Logic 2" and the double-D symbol are
trademarks of Dolby Laboratories. Confidential
Unpublished Works. ' 1992-1997 Dolby Laboratories,
AM LOOP Inc. All rights reserved.
CENTER SUB
FRONT VCR
1
IN OUT
R L
FM 75‰
L
This device complies with part 15 of the FCC rules. Operaton is
R L
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any R
interference received, including interference that may cause
undesired operations
REAR
S P E A K E R S A U D I O
OPTICAL DIGITAL OUT
Connect to recording
device like CD, CDRW
player, DVD recorder,
mini disc etc.
S A T
COAXIAL OPTICAL OPTICAL
IN IN OUT
D I G I T A L A U D I O
V C R I N
AUDIO VIDEO RECEIVER
POWER SOURCE: 120V 60Hz
POWER CONUMPTION: 300W
REFER INQUIRIES TO: 110V 60Hz
SAT
THOMSON MULTIMEDIA INC. V C R O U T
MANAGER CONSUMER RELATIONS,
IN
P.O. BOX 1976, INDIANAPOLIS, IN46206
MADE IN CHINA
S A T SAT
IN
MON
OUT
COAXIAL OPTICAL OPTICAL
IN IN OUT
D I G I T A L A U D I O V I D E O
Getting Started
Connecting the Antennas
Manufactured under licence from Dolby Laboratories.
"Dolby", "Pro Logic 2" and the double-D symbol are
trademarks of Dolby Laboratories. Confidential
Unpublished Works. ' 1992-1997 Dolby Laboratories,
AM LOOP Inc. All rights reserved.
CENTER SUB
FRONT VCR
1
IN
R L
FM 75‰
L
This device complies with part 15 of the FCC rules. Operaton is
R L
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any R
interference received, including interference that may cause
undesired operations
REAR
S P E A K E R S A U D I O
The AM and FM antennas connect to the AM and FM ter-
minals on the system's back panel.
They must be hooked up in order to receive clear reception.
AM Loop Antenna and FM Indoor Antenna
1. Uncoil the AM Antenna wire.
2. Press down on the Antenna tab to open the terminal
(Refer to the illustration on the bottom of page 6)
White
AM LOOP
GND
FM 75 Ω
HINT
• For FM reception, extend antenna to its full
length and arrange the Antenna at different parts
of the room until the reception is optimized.
• For AM reception, rotate the antenna
horizontally to get better reception.
V C R I N
AUDIO VIDEO RECEIVER
POWER SOURCE: 120V 60Hz
POWER CONUMPTION: 300W
REFER INQUIRIES TO: 110V 60Hz
SAT
THOMSON MULTIMEDIA INC. V C R O U T
MANAGER CONSUMER RELATIONS,
OUT IN
P.O. BOX 1976, INDIANAPOLIS, IN46206
MADE IN CHINA
S A T SAT
IN
MON
OUT
COAXIAL OPTICAL OPTICAL
IN IN OUT
D I G I T A L A U D I O V I D E O
EN
5