Heat & Glo PORTRAIT-6-BK Installation Instructions Manual

Models: 6K,8K, 6KL,8KL, 6KX, 8KX, 6KMOD, 8KMOD
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and must be installed for
the protection of children and other at-risk
individuals.
WARNING! Risk of Fire! Combustible materials MUST
NOT overlap or be placed behind a decorative front.
CAUTION! Do not install damaged components.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specified.
Overlapping materials could ignite and will interfere with
proper operation of decorative fronts.
IMPORTANT INSTALLATION INFORMATION
MAINTAIN required mantel and TV clearances to avoid
damage to finishing materials and/or TV.
1
Portrait Decorative Front
PORTRAIT-6-BK, PORTRAIT-8-BK
- Installation Instructions -
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
Heat & Glo • Portrait Decorative Front Instructions • 2581-930 Rev. C • 8/22
Special TV and Mantel Clearance Requirements
The Portrait decorative front has unique requirements for
clearances to TV's and mantels. Verify that the appliance
is installed in compliance with the required clearances to
mantels. The installation must comply with the specified
TV Guidelines and Combustible Mantel and Non-Com-
bustible Mantel diagrams included in this instruction.
Refer to the appliance Installation Manual for additional
information.
Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances as specified. Mantel MUST be fastened to wall
with no gaps.
• Framing closer than the minimums listed must be
constructed entirely of non-combustible materials (i.e.,
steel studs, concrete board, etc.).
• No gaps allowed between the wall and the bottom of the
mantel.
• Combustible mantel legs and wall projections may be
applied over the non-combustible board supplied with
the appliance. Follow guidelines as shown in the figures
below for mantels, mantel legs and wall projections.
Note: Measurement is taken from top/side of the
opening, NOT the top/side of the appliance.
Verify that mantel clearance requirements are maintained
for combustible or non-combustible mantels as shown in
Figure 1 and Figure 2. Refer to Figure 3 and Figure 4 if
the Passive Heat Kit is installed.
Good Faith TV Guidelines
See Figure 5 for TV Clearances.
Good Faith Wall Surface Temperatures
See Figure 6 for wall surface temperatures. Note that
temperatures vary based on appliance model installed
and whether or not the Passive Heat Kit is installed.