Troubleshooting - IKEA KULINARISK Manual

ENGLISH
for the symbol / printing on the side of the
glass panel, each of the glass panels looks
different to make the disassembly and
assembly easier.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame on the screen-printing zones is not
rough when you touch it.
When installed correctly the door trim clicks.
A B C
Make sure that you install the middle panel
of glass in the seats correctly.

Troubleshooting

Warning! Refer to Safety
chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
Replacing the lamp
Put a cloth on the bottom of the interior of
the oven. It prevents damage to the lamp
glass cover and the cavity.
1. Turn off the oven.
2. Remove the fuses from the fuse box or
3. Turn the lamp glass cover
4. Clean the glass cover.
5. Replace the oven light bulb with a 40 W,
6. Install the glass cover.
A
B
C
Possible cause
The oven is turned off.
The clock is not set.
Warning! Danger of
electrocution! Disconnect the fuse
before you replace the lamp.
The lamp and the lamp glass
cover can be hot.
Caution! Always hold the halogen
lamp with a cloth to prevent
grease residue from burning on
the lamp.
turn off the circuit breaker.
counterclockwise to remove it.
230 V (50 Hz), 350 °C heat resistant oven
light bulb (connection type: G9).
Turn on the oven.
Set the clock.
29
Remedy