Table of Contents
Advertisement
Other Information
Troubleshooting
Common Problem
No Power
Power turns itself off
Player fails to start, even
when PLAY is pressed
Play commences but then
stops immediately
No picture
Picture is distorted during
forward and reverse scan
No sound or distorted sound
No operations can be
performed with remote
The
icon appears on screen • The feature or action cannot be completed at this
58
Solution
Insert the power cord's plug securely into the outlet.
The power is automatically turned off after approx 30
minutes have elapsed in the stop mode (auto power-off
feature). Turn power back on.
• Ensure that the disc is installed with the label side
facing up.
• This player plays only DVD discs, Audio CDs and
Video CDs.
• The disc is dirty. Clean it.
• Condensation has formed. Allow player to dry out.
• Ensure that the equipment is connected properly.
• Turn on the TV's power.
• Ensure that the input setting for the TV is correct.
• It is normal for some distortion to appear while
scanning.
• Ensure that the equipment is connected properly.
• Ensure that the input settings and the volume
adjustment for the TV and/or receiver are correct.
• No sound is heard during still, frame advance, or slow-
motion play.
• The batteries in the remote may need replacing.
• Operate the remote control closer to the DVD player.
• Remove any obstacles between the remote and the
DVD player or other component.
• Remove batteries and hold down one or more buttons
for 60 seconds to drain the microprocessor inside the
remote to reset it. Reinstall batteries and try remote
again. You may need to reprogram it.
time because:
1. The DVD's software restricts it.
2. The DVD software doesn't support the feature
(e.g., angles).
3. The feature is not available at the moment.
4. You've requested a title or chapter number or
search time that is out of range.
Chapter 6
Advertisement
Table of Contents
