Craftsman 137.418000 Operator's Manual page 28

2. Move the turntable while lifting up
on the positive stop lock lever (2)
to align the pointer (3) to the desired
degree measurement.
3. If the desired angle is one of the
nine positive stops, release the
positive stop lock lever (2), making
sure the lever snaps into position,
and then secure by tightening the
miter handle (1).
4. If the miter angle desired is not one
of the nine positive stops, simply
lock the miter table into desired
angle position by turning the miter
handle (1) in the clockwise direction.
Fig. S
4
MITER SCALE POINTER
ADJUSTMENT (FIG. S)
1. Move the table to the 0° positive
stop.
2. Loosen the screw (4) that holds the
pointer with a Phillips screwdriver.
3. Adjust the pointer (3) to the 0° mark
and retighten screw.
3
2
1
ADJUSTING FENCE SQUARENESS
(FIG. T)
1. Lower the cutting arm and lock in
position.
2. Using a square (1), lay the heel of
the square against the blade and
the ruler against the fence (2) as
shown.
3. Loosen the four fence locking
bolts (3) with a 6 mm hex wrench.
4. Adjust the fence 90° to the blade
and tighten the four fence locking
bolts (3).
CAUTION: If the saw has not
been used recently, recheck
blade squareness to the fence
and readjust if needed.
5. After fence has been aligned, using
a scrap piece of wood, make a cut
at 90° then check squareness on
the piece. Readjust if necessary.
Fig. T
2
3
1
28
3