Using The Battery; Charging - RCA CC4352 User Manual

Power Your Camcorder
Use the Battery to Power Your Camcorder
Charge the Battery
The battery must be charged before it can be used the first time. Initial charging takes
approximately two hours. The camcorder's operating time depends on how often you
turn the power on and off and how much you use the monitor, zoom, and pause. To
conserve battery power, turn the camcorder off during recording breaks.
To AC 120V,
50/60 Hz
WARNING;
LEAD ACID
BATTERY.
MUST BE
DISPOSED OF
PROPERLY.
CHARGE
Indicator
Caution: When a battery is attached to the adapter/charger, do
not turn them upside down. The battery might fall off and be
damaged or cause injury.
Charge the Battery
If the DC cable is attached to the
DC OUTPUT jack on the adapter/charger,
remove it.
1. Align reference mark on battery with
mark on adapter/charger.
2. Hold the battery flush against the
adapter/charger and slide it in the
direction of the arrow.
3. Plug adapter/charger into nearest AC
outlet (120V, 50/60Hz).

Using the Battery

Charging

Rechargeable Battery
(Hold battery flush and
slide down.)
4. If the battery is properly connected,
the adapter/charger's CHARGE
indicator lights.
Note: Your battery will provide better
service if you charge it before and after use
and store it at room temperature.
5. Remove the charged battery by sliding
it up and off the adapter/charger.
6. Attach the charged battery to the
camcorder as shown on the next page.
Align
Arrows
Adapter/
Charger
13