Heat & Glo PRIMO-II Series Installation Instructions

STONES-36, STONES-48, STONES-60, STONES-72
MODELS: PRIMO-II Series, PRIMO Series, MEZZO-B Series, MEZZO-C Series, MEZZO-AUB Series
Leave this manual with party responsible for use
and operation.
WARNING! Choking Hazard! Keep stones out of reach
of children.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
CAUTION! Risk of Burns! The fireplace should be turned
off and cooled before media and stones are installed.
KIT COMPONENTS
Ceramic Stones
The number of stones used varies by model size. See
Table 1.
KIT NAME STONE QUANTITY
STONES-36 15
STONES-48 20
STONES-60 25
STONES-72 30
Table 1.
PREPARATION
1. Remove front and glass assembly. Refer to appliance
installation manual for glass removal and replacement
instructions.
2. Glass media is required with the PRIMO, PRIMO-II,
MEZZO-B, MEZZO-C and MEZZO-AUB appliances and
must be installed prior to placing stones. Install media
according to instructions included in glass media kit.
Note: Crushed glass media includes MEDIA-FOG.
Heat & Glo • STONES-36, STONES-48, STONES-60, STONES-72 Installation Instructions • 2310-948 Rev. G • 5/23
- Installation Instructions -
MODEL NAME
MEZZO36-B, -C
MEZZO36ST-B, -C
MEZZO1000-AUB
MEZZO48-B, -C
MEZZO48ST-B, -C
PRIMO48
PRIMO48ST
PRIMO-II-48
PRIMO-II-48ST
MEZZO1300-AUB
MEZZO1300ST-AUB
MEZZO60-B, -C
MEZZO60ST-B, -C
PRIMO60
PRIMO60ST
PRIMO-II-60
PRIMO-II-60ST
MEZZO1600-AUB
MEZZO72-B, -C
MEZZO72ST-B, -C
PRIMO72
PRIMO72ST
PRIMO-II-72
PRIMO-II-72ST
WARNING
Delayed Ignition Risk
• Place stones according to instructions.
• Do NOT place stones on the burner.
• Do NOT use any media or stones other than the
Hearth & Home Technologies-supplied options
for this fireplace model.
Fireplace will not function properly.
Delayed ignition could occur.
LOGS INSTALLATION
The stone kit cannot be used in conjunction with logs on
the PRIMO-II series. All other series may use the stone kit
in conjunction with optional log sets. If using logs, install
logs according to instructions included in log kit prior to
installing stones.
STONES INSTALLATION
Note: Maximum amount of stones that may be used in
the PRIMO-II series is one set.
1. If an optional log kit has been installed, the maximum
amount of stones that may be used is one set. If an
optional log set is not installed, two sets of stones may
be used.
2. Refer to Table 1 for the stones kit names and corre-
sponding appliance models. Use only the appropriate
stones kit for each model listed.
NOTICE: DO NOT EXCEED MAXIMUM AMOUNT OF
STONES. Place stones as instructed.
mance could be impacted. Sooting could occur.
3. DO NOT place stones on the burner or within 1/2 inch
of the burner. See Figure 1.
WARNING! Risk of Explosion! DO NOT place stones on
burner! Delayed ignition could occur.
NO STONES ON BURNER NO STONES ON BURNER
Figure 1. Stones Not Allowed on Burner
Flame perfor-
1