Advertisement
Set!
Installing the oven accessories
1.
Install telescopic slides to the side racks
(EVE614 only). Refer to installation guide
supplied with oven slides.
2. Insert side racks
1. Insert the rear peg into the rear access hole,
ensuring peg is fully inserted.
2. Then insert the front peg into the front access
hole and push in firmly.
3. To fit a shelf:
1. Locate the detents on the side wires
of the shelf, these should be towards
the oven back wall. See image below.
2 Align the shelf to the same rail
positions on both sides and slide
the shelf in between the guide rails.
3. When fully inserted the shelf should not
interfere with the closed oven door.
Detent
Set the time
You must set the time before you can operate your oven.
1. After the appliance has been electrically connected,
'12:00' will be displayed and the clock icon
2. Use the timer + and - to set the time.
3. 5 seconds after the last change, the clock icon will
disappear, confirming the time has been adjusted.
NOTE: The clock has a 24 hour display
4. Fit shelf to telescopic slides
(EVE614 only)
1. Push the shelf along the
top of the slide until it hits the
back post.
Shelf
Condition the oven
(to burn off any residue)
New appliances can have oil or residue left from
manufacturing. You will need to heat your oven for
will flash.
30 minutes before using it for the first time.
1. Turn the function selector knob to FAN BAKE.
2. Using the temperature selector, set the oven to 180°C
2. Drop the front of the shelf onto the
slide ensuring it sits behind the front
post of the slide.
Back post
3. When fully inserted the shelf
should not interfere with the closed
oven door.
and heat for approximately 30 minutes. Make sure
your room is well ventilated during this time.
Front post
Shelf
Advertisement
