8.
Remove the old sealing washer ( ) and
install a new sealing washer on the drain bolt.
9.
Install the oil drain bolt and tighten to the
specified torque:
18 lbf·ft (24 N·m , 2.5 kgf·m)
10.
Pour the recommended oil into the crankcase,
approximately:
1.0 US qt (0.9 )
Install the oil filler cap/dipstick securely.
11.
Start the engine. Let it idle 3-5 minutes, then
12.
turn it off.
2
13.
With the motorcycle held upright on level
ground, check the oil level.
If needed, add oil (page
the upper level mark. (Do not overfill.)
14.
Check for oil leaks.
Engine Oil
63
) until it reaches
Servicing Your Honda
65