Honda CRF80F 2009 Owner's Manual page 101

RIGHT REAR
(9)
(7) lug
(8) slot
(9) brake panel
Installation
1. Reverse the removal procedure. Make sure
the lug ( ) on the swingarm is located in the
slot ( ) in the brake panel ( ). Check that 8
the chain adjusters are installed properly.
2. Adjust the drive chain (page
(7)
3. Torque the rear axle shaft nut to:
46 lbf·ft (62 N·m , 6.3 kgf·m)
(8)
4. Adjust the rear brake (page
5. Apply the rear brake, release it, then spin the
wheel and check that it rotates freely. Repeat
this procedure several times.
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
7
9
102
85
Servicing Your Honda
Wheels
).
).
93