Step 1: Physical Installation; Direct Mount - Emerson Rosemount 702 Quick Installation Manual

Rosemount 702
S 1: P
TEP HYSICAL
The Rosemount 702 and all other wireless devices should be installed only after the 1420
Wireless Gateway has been installed and is functioning properly. Wireless devices should
also be powered up in order of proximity from the 1420 Wireless Gateway, beginning with
the closest. This will result in a simpler and faster network installation.
The Rosemount 702 can be installed in one of two configurations: Direct Mount, where the
switch is connected directly to the 702 housing's conduit entry, or Remote Mount, where the
switch is mounted separate from the 702 housing, then connected to the 702 via conduit.
Choose the installation sequence that corresponds to the mounting configuration.

Direct Mount

The direct mount installation should not be used when installing with a Swagelok
1. Install the switch according to standard installation practices. Be sure to use thread
sealant on all connections.
2. Attach the 702 housing to the switch using the threaded conduit entry.
3. Attach the switch wiring to the terminals as indicated on the wiring diagram.
4. Connect the battery pack.
NOTE:
Wireless devices should be powered up in order of proximity from the 1420 Wireless
Gateway, beginning with the closest device to the 1420. This will result in a simpler
and faster network installation.
5. Close the housing cover and tighten to safety specification. Always ensure a proper seal
by installing the electronics housing covers so that metal touches metal, but do not over
tighten.
6. Position the antenna such that it is vertical, either straight up or straight down.
4
I
NSTALLATION
Possible antenna rotation shown.
Antenna rotation allows for best
installation practices in any
configuration.
Quick Installation Guide
00825-0100-4702, Rev BA
August 2009
®
fitting.