Fujitsu AOU9RLFF Design & Technical Manual page 32

6) Remote controller custom code
(Only for wireless remote controller)
The indoor unit custom code can be changed.
Select the appropriate custom code.
Function number
44
7) External input control
"Operation/Stop" mode or "Forced stop" mode can be selected.
Function number
46
8) Room temperature sensor switching (Aux.)
To use the temperature sensor on the wired remote controller only, change the setting to
"Wired remote controller" (01). This function will only work if the function setting 42 is set at
"Both" (01).
Function number
48
9) Indoor unit fan control for energy saving for cooling
Enables or disables the power-saving function by controlling the indoor unit fan rotation when
the outdoor unit is stopped during cooling operation.
Function number
49
00: When the outdoor unit is stopped, the indoor unit fan operates continuously following the setting on the
remote controller.
01: When the outdoor unit is stopped, the indoor unit fan operates intermittently at a very low speed
(  ... Factory setting)
Setting value Setting description
00
01
02
03
Setting value Setting description
00 Operation/Stop mode
01 (Setting prohibited)
02
Setting value Setting description
00
01 Wired remote controller
Setting value
00
01
- (01 - 29) -
A

B
C
D
(  . . .Factory setting)

Forced stop mode
(  . . .Factory setting)
Both

(  . . .Factory setting)
Setting description
Disable
Enable

.