Advertisement
NAV 10SD 501 and NAV 10SD 101 • Setup Guide (Continued)
1 1 1 1 1 1
1 1 1 1 1 1 1 1
1 1 1 1
* NAV 10SD 501 only
HTML Page
Figure 5.
NOTE:
Detailed descriptions of communication, configuration, and monitoring are provided in the NAV 10SD 501 and
NAV 10SD 101 User Guide, available at www.extron.com.
Connection settings
View and change connection settings as follows:
On the home page, click Settings (see figure 5,
1.
Connection (
2
). The Network Connection pane opens (see figure 6),
showing protected views of the network connection settings.
NOTE
Editing of connection settings is disabled when the
:
device is assigned to an Extron NAVigator System Manager.
To change the settings, click Edit (see figure 6,
2.
changes to Save.
Click in the desired field (
3.
Repeat step 3 as necessary for other values.
4.
Click Save.
5.
Pairing devices via front panel
Pair devices as follows:
Use a Tweeker or other small screwdriver to press
1.
and hold the encoder front panel ID button for
approximately 3 seconds, until the ID LED blinks. The
encoder enters pairing mode, which allows decoders
to receive the AV stream (NAV 10E 101) or AV and USB
streams (NAV 10E 501 only) from encoders.
One at a time, use a Tweeker or other small screwdriver to press and
2.
hold the decoder front panel ID button for approximately 3 seconds,
until the ID LED blinks three times. The decoder is now paired to the
encoder.
2 2 2 2
2 2 2 2 2 2 2 2
2 2 2 2 2 2
*
1
) and then Network
1
). The Edit button
) and edit it as necessary.
2
ID
AV
A V
A
AV 10E 101
V
V
V
V
* NAV 10SD 501 only
Figure 6.
2 2 2 2 2 2 2 2
2 2 2 2
2 2 2 2 2 2
*
1 1 1 1
1 1 1 1 1 1 1 1
1 1 1 1 1 1
Network Connection Pane
5
Advertisement
