Philips NORELCO 5000 Series Manual page 12

ENGLISH
22
C
1 Press the shaver head release button to
open the shaving unit.
C
2 Pull the shaving head holder off the
bottom part of the shaving unit.
C
3 Turn the retaining ring counterclockwise
2
(1) and lift it off the shaving head (2).
1
C
4 Remove the shaving heads from the
shaving head holder and discard.
DO NOT discard the retaining ring.
C
5 Place a new shaving head in the holder.
Make sure the projections of the shaving head
fit exactly into the recesses on the shaving head
holder.
C
6 Hold the shaving head holder in your hand
and place the retaining ring on the shaving
1
head holder (1). Turn clockwise (2) to
reattach the retaining ring.
2
Do not place the shaving head holder on a
surface, as damage may occur.
7 Repeat this process for the other two
cutters and combs.
C
NOTE: Each retaining ring has two recesses and
two projections that fit exactly in the projections
and recesses of the shaving head holder. Make sure
you hear a 'click' indicating the retaining ring is fixed
into place.
C
8 Reinsert the hinge of the shaving head
holder into the slot of the shaving unit.
Close the shaving head holder (click).
C
9 To reset the shaver, press and hold the On/
Off button for approximately 7 seconds.
7 sec.
shaving head holder and discard.
This shaver has no other user-serviceable parts.
For assistance, call 1-800-243-3050.
ENGLISH
23