Table of Contents
Advertisement
Main Menu
Playing Discs (Models with navigation system)
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
Loading Discs in the Changer
To load multiple discs in one
operation:
1. With the ignition in the
ACCESSORY (I) or the ON (II)
position, press and hold the LOAD
button until you hear a beep and
see ''LOAD'' in the upper display,
then release the button.
2. Insert a disc into the slot. Insert it
only about halfway; the drive will
pull it in the rest of the way. You
will see ''BUSY'' in audio display.
When you insert the first disc, the
changer will start to play the disc.
220
Table Of Contents
3. When ''LOAD'' appears in the
audio display again, insert the next
disc into the slot.
Do not try to insert a disc until
''LOAD'' appears. You could
damage the audio unit.
4. Repeat this until all six positions
are loaded. If you are not loading
all six positions, the system will
then begin playing the last disc
loaded.
If you stop loading discs before all
six positions are filled, the system
will wait for 10 seconds, stop the load
operation, and begin playing the last
disc loaded.
To load a single disc:
1. Press and release the LOAD
button.
2009 MDX
2. ''NO DISC'' is shown on the screen
for an empty position in the
changer. When the green load
indicator comes on and you see
the ''LOAD'' in the audio display,
insert the disc into the slot. Insert
it only about halfway; the drive will
pull it in the rest of the way.
You can select the position to load a
disc. Turn the interface knob or
press a preset button to select the
position, then press ENTER on the
selector. This starts the loading
sequence. If you do not select the
position, the system loads the disc to
the first empty position in numerical
order.
If you press the LOAD button while a
disc is playing, the system will stop
playing that disc and start the loading
sequence. It will then play the disc
just loaded.
Advertisement
Chapters
Table of Contents
