Mercedes-Benz Black Series Operator's Manual page 199

Programming
Programing buttons
Pay attention to the "Important safety notes"
( page 196).
Y
Integrated garage door opener in the rear-view
mirror
Garage door remote control A is not part of
the integrated garage door opener.
Before programing for the first time, clear
X
the integrated garage door opener memory
( page 199).
Y
Select key position 2 with the Start/Stop
X
button ( page 111).
Y
Press and hold one of buttons ; to ? on
X
the integrated garage door opener.
After a short time, indicator lamp : lights
up yellow.
i
Indicator lamp : lights up yellow as soon
as button ;, = or ? is programed for the
first time. If the selected button has already
been programed, indicator lamp : will
only light up yellow after ten seconds have
elapsed.
Release button ;, = or ?.
X
Indicator lamp : flashes yellow.
Point garage door remote control A
X
towards buttons ; to ? on the rear-view
mirror at a distance of 2 to 8 inches (5 to
20 cm).
i
The required distance between remote
control A and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be
necessary. You should test every position
for at least 25 seconds before trying
another position.
Press and hold button B on remote control
X
A until indicator lamp : lights up green.
If indicator lamp : lights up green or
flashes, then programing was successful.
Release button B on remote control A for
X
the garage door drive system.
If indicator lamp : lights up red: repeat
X
the programing procedure for the
corresponding button on the rear-view
mirror. When doing so, vary the distance
between remote control A and the rear-
view mirror.
i
If the indicator lamp flashes green after
successful programing, the garage door
system is using a rolling code. After
programing, you must synchronize the
garage door opener integrated in the rear-
view mirror with the receiver of the garage
door system.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
( page 196).
Y
Your vehicle must be within reach of the
garage door or exterior gate drive. Make sure
that neither your vehicle nor any persons/
objects are present within the sweep of the
door or gate.
Select key position 2 with the Start/Stop
X
button ( page 111).
Y
Press the programing button of the door or
X
gate drive (see the door or gate drive
operating instructions, e.g. under
"Programing additional remote controls").
i
Usually, you now have 30 seconds to
initiate the next step.
Press previously programed button ;, =
X
or ? of the integrated garage door opener
until the door closes.
The rolling code synchronization is then
complete.
Features
197
Z