Cleanup
1. Perform Pressure Relief Procedure, page 7.
Remove siphon tube set from paint and place in
flushing fluid. Remove tip guard from gun.
NOTE: Use water for water-base paint, mineral spir-
its for oil-base paint, or other solvents recom-
mended by manufacturer.
2. Start Engine
a. Move fuel valve to open.
ti5248a
b. Move choke to closed.
ti5249a
c. Set throttle to fast.
ti5250a
334121B
ti14844a
d. Set engine switch to ON.
3. Pull rope to start engine.
ti5263a
4. Turn pump switch ON. Turn prime valve forward to
SPRAY position.
ON
OFF
ti22729a
ti22729a
5. Increase pressure to 1/2. Hold gun against paint
pail. Disengage trigger lock. Trigger gun until flush-
ing fluid appears.
ti22730a
Cleanup
ti5262b
ti14846a
11