Table of Contents
Advertisement
We know wiring is hard. Let's make it easier.
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch
setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician.
WARNING
The ceiling fan must be grounded. If the
ground wire for the installation site is not
present, immediately STOP installation and
consult a qualified electrician.
Connect the black
(ungrounded) wire from
the ceiling to the black
wire from the receiver.
Connect the white (grounded)
wire from the ceiling to both
the white wire from the
receiver and the white wire
from the fan.
bag
Wire Nut
Ceiling Bracket
Downrod
WARNING
All wiring must be in accordance with
national and local electrical codes ANSI/NFPA
70. If you are unfamiliar with wiring or in
doubt, consult a qualified electrician.
White
x4
Hanging Fan
Wiring
Wiring the Fan
Hunter Pro Tip:
Have extra wiring?
Turn the wires upward and push them carefully back through
the hanger bracket into the outlet box. Spread the wires apart,
with the grounded wires on one side of the outlet box and the
ungrounded wires on the other side of the outlet box. Make
sure that the wires are still attached to the wire nuts.
Canopy
Blades
Hunter Pro Tip:
Here is how to connect the wires:
Push the bare metal ends of the wires together and slide a wire
nut over them. Then, twist the wire nut clockwise until tight.
Give it a gentle pull to make sure none of the wires are loose.
Slide the remote
receiver onto the
top of the bracket.
Connect the yellow
wire from the
receiver to the black
wire from the fan.
Connect the blue wire
from the receiver to the
blue wire from the fan.
Light
Bulbs/Glass
Remote
1886
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling, downrod, and
hanging bracket.
6
Remote Cradle
Advertisement
Table of Contents
