Life Fitness 4500HR Service Manual page 22

Life Fitness Model 4500HR Treadmill
How To ... REMOVE AND REPLACE THE HANDLEBAR AND HANDRAILS
Tools Required: Phillips Screwdriver, hex key wrench set
Step 1
Turn the power OFF at the ON/OFF switch and then unplug the unit from the electrical outlet.
Step 2
Remove the DISPLAY CONSOLE. (See "How To...").
Step 3
Remove the two HEX KEY SCREWS securing the center of the foam padded HANDLEBAR to the top of the
MONOCOLUMN.
Step 4
Loosen and remove the 2" (top) and the 2-1/2" (bottom) SCREWS securing the base of each of the two VERTICAL
POSTS to the FOOT BRACKETS located on either side of the treadmill.
Step 5
Lift the entire HANDLEBAR/HANDRAIL ASSEMBLY away from the machine and set it down on the floor. Remove
the SCREW securing each of the two VERTICAL POSTS to the foam padded HANDLEBARS and slide the
POSTS from the HANDLEBARS.
Step 6
Replace the VERTICAL POST(S) or HANDLEBAR as desired and reverse Steps 1 through 5 to return all parts to
their proper positions. Make sure that the 2-1/2" SCREWS are located at the bottom hole of the FOOT
BRACKETS securing the VERTICAL HANDRAILS when re-assembling the unit.
4