Reading Techniques; Standard Product Defaults - Honeywell Voyager 1452g Series Quick Start Manual

Reading Techniques

The view finder projects an aiming
beam that should be centered over
the bar code, but it can be
positioned in any direction for a
good read.
Hold the scanner over the bar code,
pull the trigger, and center the
aiming beam on the bar code.
The aiming beam is smaller when
the scanner is closer to the code and larger when it is farther from the
code. Hold the scanner close to smaller bar codes, and farther away
from large bar codes to get a proper read.
If the bar code is highly reflective (e.g., laminated), you may need to
tilt the scanner at an angle so the bar code can be scanned.
Note: If the scanner razzes when scanning a bar code, the link has
not been established. If the scanner beeps once, the link has
been established.

Standard Product Defaults

The following bar code resets all standard product default settings.
Note: PDF and 2D bar codes can only be read by Voyager model
1452g2D and cannot be read by model 1452g1D.
Standard Product Defaults