Operating Instructions - Kenmore K PA3D0AMW Series Use & Care Manual

OPERATING INSTRUCTIONS

Note: Before operating the air purifier, record the date of installation on the
HEPA filter. Under normal use conditions (12 hours a day), the HEPA filter
should be replaced once a year, and the carbon filter should be replaced every
3 months. See Filter Replacement instructions.
1. Check the Air Purifier filters. Before turning unit on, be sure filters are
correctly in place, and that any plastic packaging has been removed from
filters.
2. Place the Air Purifier on a hard surface such as the floor, table, or desk. Be
sure the grills are not blocked by other objects and that there are no candles
or flames near the unit. The Air Purifier can be positioned upright or on its
back in a horizontal position for operation.
3. Connect unit end of power cord into port at base of unit back side. Plug wall
end of power cord into the nearest standard electrical outlet.
4. Press the POWER button [
button again to turn the Air Purifier off.
5. Select the level of airstream strength by pressing the Operation Mode Select
button [ ] until the preferred mode illuminates. Every time you press the
button, the mode is adjusted in the order shown below:
Mode
Turbo
Auto
Sleep
6. Indoor Air Quality Display
7. The Filter Replacement Indicator light [
the HEPA filter expires. Press
seconds after stopping the product and replacing the HEPA filter and the
lamp will turn off and reset.
] to turn the Air Purifier on. Press the POWER
Display
Strongest airstream level
Automatically operates at Strong/Medium/Mild
airstream level according to indoor air quality
Mild airstream level
Indicator light illuminates according to air quality
Upper: Light Blue = Good air quality
Middle: Green = Fair air quality
Lower: Orange = Poor air quality
Operation
] turns on once the lifespan for
Operation Mode Select button [
5
] for 3