Typical Installations; Installation - Kenmore Deluxe 625.384450 Owner's Manual

A. INSTALLATION ON COPPER PLUMBING USING COMPRESSION FITTINGS
MATERIALS & TOOLS NEEDED
2 compression adaptors, 3/4" NPT x com-
pression end to fit existing copper pipe
Teflon tape
Tubing cutter
Sandpaper or emery cloth
2 wrenches, either open end or adjustable
jaw, sized to fit compression adaptors
NOTE: Be sure to allow a minimum space of 2" under the
B. SOLDERED COPPER INSTALLATION
WATER
IN
Optional
3/4" Copper
Shutoff
Pipe, as
Valve (2)
required
See Note in Figure 3
C. THREADED INSTALLATION
WATER
IN
Optional
3/4"
Shutoff
Nipple
Valve (2)
(2)
See Note in Figure 3
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
6

Typical Installations

WATER
IN
filter for removing the sump (to change the cartridge).
IN OUT
Adaptor, 3/4" NPT
x Sweat (Apply
4 wraps of
Teflon Tape)
IN OUT
3/4" Hex Union
Fitting
Nipple
(2)
Apply 4 wraps of
Teflon Tape
Optional
Shutoff
Valve
INLET
3/4" NPT
D. UNDERSINK INSTALLATION
(Filtering Water to One Faucet)
WATER
OUT
Figure 4
NOTE: To change the filter
WATER
OUT
(2)
Figure 5
Optional
Shutoff Valve
Brass
Ferrule
Compression
Adaptor
SINK
IN
COLD
Shutoff Valve
cartridge, refer to
the instructions on
Pages 11 & 12 in
NOTE: Be sure to allow
this manual.
WATER
OUT
Nut
Figure 3
OUT
a minimum
space of 2" under
the filter for
removing the
sump (to change
the cartridge).
Figure 6