Starting And Shutting Off The Engine; Using The Motion-Control Levers; Driving The Machine - Toro 75210 Operator's Manual

Starting and Shutting Off
the Engine
Starting the Engine
Note:
A warm or hot engine may not require choking.
Important:
Do not engage the starter for more
than 5 seconds at a time. Engaging the starter
motor for more than 5 seconds can damage the
starter motor. If the engine fails to start, wait 10
seconds before operating the engine starter again.
Figure 22
Shutting Off the Engine
1. Disengage the blades by moving the
blade-control switch to the O
20).
2. Move the throttle lever to the S
let the engine idle for 1 minute.
3. Turn the ignition key to the O
remove the key.
g189354
position (Figure
FF
position and
LOW
position and
FF
22
Using the Motion-Control
Levers
Figure 23
1. Motion-control
lever—N -
EUTRAL LOCK
position
2. Center, unlocked position
3. Forward

Driving the Machine

The drive wheels turn independently, powered by
hydraulic motors on each axle. You can turn 1 side
in reverse while you turn the other forward, causing
the machine to spin rather than turn. This greatly
improves the machine maneuverability but may
require sometime for you to adapt to how it moves.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the F
performance. Always operate in the full throttle
position when mowing.
4. Backward
5. Front of machine
position for best
AST
g004532