Table of Contents
Advertisement
1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
To install the shade, first loosen
the thumb screws. Raise the
shade to the light fixture. Tighten
all thumbscrews securely.
Repeat x3
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to
www.HunterFan.com/FAQs
fan without the light kit?"
Ceiling Bracket
Downrod
2 of 3
Light Kit Screw
bag
5
Lift the lower switch housing up until its
screw holes are aligned with the screw
holes in the upper switch housing.
Installing the Bulbs and Glass
Note:
and click "How do I install my
Fan style may vary.
Hanging Fan
Wiring
Assembling the Light
2
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
6
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x3
Canopy
3
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
bag
Install the three switch housing screws
found in the
hardware bag.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades
Light
1886
1 of 3
Light Kit Screw
x3
Switch Housing
Screw
ON
8
Glass/Bulbs
Advertisement
Table of Contents
