Advertisement
KBC88-W-CH
built-in freezer
drip tray
removable
shelf
leveling feet
PARTS
defrost button
thermostat
4
Before using your fridge
The temperature in the fridge will depend on:
- The temperature in the surrounding area.
- The frequency and duration when the door is open.
door seal
- Contents in the fridge
(gasket)
• Remove the exterior and interior packaging, including protective foam on door panels.
• Check to be sure the all parts are included.
• Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transpor-
tation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installation of your fridge
cans rack
• Place your appliance on a floor that is strong enough to support the appliance when fully loaded. To
level your appliance, adjust the legs at the front of the appliance.
• Allow 5 inches of space between the back and sides of the appliance, which allows the proper air
circulation to cool the compressor.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause
bottle rack
the appliance not to perform properly.
• Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form
quickly on the evaporator.
• Plug the appliance into an exclusive properly installed grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concern-
ing power and/or grounding should be directed toward a certified electrician or an authorized
products service center.
Interior light bulb replacement (KBC88-W-CH)
If the interior 15 watt appliance light bulbs burns out, follow steps below:
1. Unplug refrigerator from power outlet
2. Remove the bulb by rotating counterclockwise.
3. Insert new bulb and screw into the socket.
4. Plug refrigerator back into the power outlet.
INSTALLATION
WARNING! Improper use of the grounded plug can result in the risk
of electrical shock. If the power cord is damaged, have it replaced by
an authorized products service center.
5
Advertisement
