Mitsubishi Electric SVZ-KP18NA Service Manual page 35

11-1-1. Selecting functions using the wired remote controller
First, try to familiarize yourself with the flow of the function selection procedure. In this section, an example of setting the room
temperature detection position is given.
For actual operations, refer to steps 1 to 0 .
Mode number
F
E
G
Selecting functions using the wired remote controller
1 Check the function selection setting.
2 Switch to function setting mode.*
3 Specify refrigerant address 00 (outdoor unit).
4 Specify unit No. 00. (indoor unit)
(Use C and D .)
6 Select mode No. 02
(room temperature detection position).
7 Select setting No. 03 (remote controller fixed).
(Use F and G .)
0 End function display.*
TCH022
Setting number
C
(Press A and B at the same time
with stop the remote controller.)
5 Enter the setting.
(Press E .)
8 Enter the setting.
(Press E .)
NO
Finished
YES
(Press A and B at the same time.)
The above procedure must be carried out only if changes are necessary.
Refrigerant address Unit number
D
*For modes 15 and higher
press J and B at the same time.
(Specified indoor unit:
FAN operation)
NO
Example:
Selecting room temperature
detection position
35
I
A
Modes 01 to 14 can be activated
by pressing buttons A and B
B simultaneously, and modes 15 to
28 by pressing buttons B and J .
J
,
YES
Change refrigerant
address or unit No.
9