Fujitsu ASYG12KGTE Service Manual page 138

¢ Input signal type
• Indoor unit
Input signal type is only "Edge".
• External input and output PCB
The input signal type can be selected.
Signal type (edge or pulse) can be switched by the DIP switch 2 (S→302) on the External input
and output PCB.
NOTE: The input signal supports the following switch type:
• Edge: Alternate type switch
• Pulse: Momentary type switch
2-1. External input
Edge
Edge
The width of pulse must be
longer than 200 msec.
Pulse
- (05-12) -
2. External input and output