Poulan Pro VS225CS Instruction Manual page 5

Table of Contents

Advertisement

Available languages

Available languages

4. Slide the lower blower tube onto the upper
blower tube.
5. Turn the lower blower tube clockwise until
a click is felt to secure the lower blower
tube to the upper blower tube.
NOTE:
When the upper and lower blower
tubes are assembled together properly, the
arrows on both tubes will be aligned.
6. To remove the tubes, turn the bolt counter-
clockwise to loosen the tubes; remove the
tubes.
HIGH- -SPEED NOZZLE ASSEMBLY
When greater air speed is desired, use the
high- -speed nozzle.
1. Align the slots on the nozzle with the tabs
on the lower blower tube.
Lower Blower
Tube
2. Slide the nozzle onto the lower blower tube.
3. Turn the nozzle clockwise until a click is felt
to secure the nozzle to the lower blower
tube.
VACUUM BAG ASSEMBLY
1. Open the zipper on the vacuum bag and
insert the elbow tube.
2. Push the small end of the elbow tube
through the small opening in the bag.
Elbow
Tube
Zipper
Opening
NOTE:
Make sure edge of the small opening is
flush against the flared area of the elbow tube,
and the rib on the elbow tube is on the bottom.
3. Close the zipper on the bag. Make sure the
zipper is closed completely.
4. Remove blower tubes from engine.
High- -
Speed
Nozzle
Tab
Slot
Rib
Small Opening
-- 5 --
5. Insert the elbow tube into the blower outlet.
Make sure elbow tube rib is aligned with
the blower outlet groove.
6. Turn bolt clockwise to secure elbow tube.
VACUUM TUBE ASSEMBLY
WARNING:
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury.
1. Insert the tip of a screwdriver into the latch
area of the vacuum inlet.
Latch Area
Blower
Outlet
Latch
Area
2. Gently tilt the handle of the screwdriver to-
ward the front of the unit to release the
latch while pulling up on the vacuum inlet
cover with your other hand.
3. Hold the vacuum inlet cover open until up-
per vacuum tube is installed.
Vacuum Inlet
Rib
Groove
Stop engine and be sure
Vacuum Inlet Cover
Vacuum
Inlet
Cover
c

Advertisement

Table of Contents
loading

Table of Contents