Table of Contents
Advertisement
Problem
Washing machine vi-
brates when operating
or is noisy.
Washing has not been
spun.
Water is leaking out un-
derneath the washing
machine.
EF0 appears. END indi-
cator flashes 15x, at the
same time an acoustic
signal sounds 15x.
The drain pump runs
constantly, even when
the machine is switched
off.
Washing water is foam-
ing excessively. At the
end of the washing cy-
cle, the spin stops. OVER
DOSING indicator is lit.
E20 appears.
END indicator flashes
2x, at the same time an
acoustic signal sounds
2x.
(Problems with water
outflow.)
Possible cause
Transport lock has not been
removed.
Screw feet not correctly ad-
justed.
Only a few large items of
washing in the drum.
Screw connection on the in-
let hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
The Aqua Control anti-flood
system has responded.
Probably too much deter-
gent has been used.
Kink in the drain hose.
Maximum pumping height
of 1m exceeded.
Drain pump is blocked.
With connection to sink
outlet: sink outlet is
blocked.
Remedy
Remove transport lock.
Adjust feet according to the
Installation and Connection
instructions.
Always load the drum as full
as possible. Mix large and
small items.
Tighten inlet hose.
Replace drain hose.
Close cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Turn off the tap, remove the
mains plug from the socket
and contact the Customer
Care Department.
Dose detergent exactly as in-
structed by manufacturer.
Remove kink.
Please contact the Customer
Care Department.
Switch off appliance. Pull out
mains plug.
Clean drain pump. Remove
foreign bodies from pump
housing.
Clean out sink outlet.
21
Advertisement
Table of Contents
