Nikon MH-61 - EN-EL5 Lithium-ion Batteries Charger Manual

Also See for MH-61:

Instruction manual (2 pages)

Instruction manual (4 pages)

Table of Contents

Contents

1 Introduction
2 Overview
3 Recharging Nikon EN-EL5 Rechargeable Li-ion Batteries (Figure 2)
- 3.1 Battery charger recharging state and recommendations
4 Specifications
5 Documents / Resources
- 5.1 Download manual

Nikon MH-61 - EN-EL5 Lithium-ion Batteries Charger Manual

Introduction

Thank you for your purchase of an MH-61 Battery Charger. The MH-61 is used to recharge Nikon EN-EL5 rechargeable lithium-ion batteries.

Before use, read the warnings and other information in this manual and in the documentation for your Nikon EN-EL5 rechargeable battery.

Safety Precautions

To ensure proper operation, read this manual thoroughly before using this product. After reading, be sure to keep it where it will be read by all those who use the product.

Precautions for Use: MH-61 Battery Charger

The Nikon MH-61 can be used to re charge Nikon EN-EL5 rechargeable lithium-ion batteries only. Do not attempt to recharge any other batteries with the MH-61.

Once charging is complete, remove the EN-EL5 from the battery charger.
Unplug the power cable from the power outlet when not in use.
Do not short the charger terminals. Failure to observe this precaution could result in damage or overheating.
Be sure to use the charger face-up as shown in Figure 2, and do not tilt the charger while charging.

Precautions for Use: Nikon EN-EL5 Rechargeable Li-ion Battery

The battery is not fully charged at the factory. Charge the battery before use.
When recharging, the ambient temperature should be between 5–35°C (41–95°F).
The internal temperature of the battery may rise while the battery is in use. If you attempt to recharge the battery while the internal tem pera ture is elevated, the battery will not charge or will charge only partially. Wait for the battery to cool before charging.
Do not attempt to recharge a fully-charged battery. Failure to observe this precaution will result in reduced battery performance.
If you shake the MH-61 Battery Charger or touch the battery while the battery is charging, the resulting vibration or static electricity may in very rare instances cause the MH-61 to indicate that charging is complete although the battery is in fact not yet fully charged. Should this occur, remove the battery and re-insert it into the MH-61 to continue charging.
Should an abnormality or malfunction occur, discontinue use immediately and request repairs from your retailer or your Nikon representative.

Overview

* Shape of cable depends on country.

Recharging Nikon EN-EL5 Rechargeable Li-ion Batteries (Figure 2)

Recharging Nikon EN-EL5 Rechargeable Li-ion Batteries - Part 1

Plug the AC adapter plug into the battery charger (Figure 2-a).
Plug the wall plug into a power outlet. The CHARGE lamp will start to glow.
Place the Nikon EN-EL5 battery in the battery bay (Figure 2-b), matching the projections on the battery with the depressions in the battery charger. The CHARGE lamp will start to blink. Charging is complete when the CHARGE lamp stops blinking (Figure 2-c).
Once charging is complete, remove the EN-EL5 (Figure 2-d) and unplug the wall plug from the power source.

Battery charger recharging state and recommendations

CHARGE Lamp	Nikon EN-EL5	Description
Glows	Not inserted	Charger plugged in Insert an EN-EL5 rechargeable battery.
Blinks	Inserted	The battery is recharging
Glows	Inserted	Charging is complete (battery is full) Remove the battery from the MH-61 as described above.
Flickers	Inserted	Temperature is outside the designated range Use the charger in side the designated temperature range. The EN-EL5 has mal func tioned * Stop recharging the battery immediately and unplug the charger.

* Take the charger and battery back to your retailer, or to your Nikon representative.

Specifications

Rated input:	AC 100–240V, 50/60 Hz, 0.12A–0.08A
Charging output:	DC 4.2 V/950 mA
Applicable batteries:	Nikon EN-EL5 Rechargeable Li-ion Battery
Charging time:	Approximately 2 hours when no charge remains
Operating temperature:	0–40°C (+32–104°F)
Dimensions (W × D × H):	Approximately 67 mm × 67 mm × 26 mm (2.6˝ × 2.6˝ × 1.0˝)
Length of cord:	Approximately 1800 mm (70.9˝)
Weight:	Approximately 70 g (2.5 oz), excluding power cable