Table of Contents
Advertisement
Processor Unit rear connectors (Enix 2680)
The rear panel of the Enix Processor Unit holds all the connectors used by the computer
to communicate with external devices. It also holds the power input socket and a mains
power switch.
Not used
A
Video cable: From Processor Unit to display (C7)
B
This is a commercial cable. The display cable is often physically attached to the
display, and terminated in the "computer end" with a male connector. If the cable is
not attached, it is normally provided with the display.
If you need to use a DVI-to-SVGA adapter to connect your display, you must use the
left DVI-I output. This is the only output that supports the SVGA signals.
Video cable (C7)
C
Serial cables: From Processor Unit to external device(s) (C10)
D
Serial cable: From Processor Unit to external device(s) (C10)
E
Ethernet cable: From Processor Unit to Transceiver Unit (C8)
F
It is very important that a high quality Ethernet cable is used. You must use CAT-5E
STP (Shielded Twisted Pair) quality or better. Using a cable with lower bandwidth
capacity will reduce the MS70 performance. Do not connect the Processor Unit to the
Transceiver Unit using an existing local area network (LAN).
G
Not used
AC power cable: From Processor Unit to uninterruptible power supply (UPS) (C3)
H
Ground cable: From Processor Unit to vessel ground (C6)
I
331549/C
Cable layout and interconnections
149
Advertisement
Table of Contents
