Table of Contents
Advertisement
PICTURE MENU
COLOR
COLOR*
4
COLOR TEMP:
COLOR CONTROL
CONTRAST*
4
ADJUST
VGA(RGB) input only
AUTO SETUP
AUTO ADJUST
H POSITION
V POSITION
CLOCK
PHASE
H RESOLUTION
V RESOLUTION
ADVANCED
HDR MODE
HDMI input only
SHARPNESS*
4
ASPECT
NORMAL
FULL
WIDE
1:1
ZOOM
ZOOM
HZOOM
VZOOM
H POS
V POS
Adjusts the color saturation of the screen. Press + or – button to adjust.
Adjusts the color temperature of the entire screen. A low color temperature will result in a reddish screen.
A high color temperature will make the screen bluish. If a temperature needs further adjustment, the
individual R/G/B/ levels of the white point can be adjusted. To adjust the R/G/B levels, set [CUSTOM] as
[COLOR TEMP] selection.
NOTE:
When [PROGRAMMABLE1], [PROGRAMMABLE2] or [PROGRAMMABLE3] is selected in
[GAMMA], this function cannot be changed.
Adjusts the hue of the Red, Yellow, Green, Cyan, Blue and Magenta colors individually. For example, you
can change red to yellow or purple.
Adjusts the image brightness in relationship to the input signal. Press + or – button to adjust.
Automatically adjusts Screen Size, H position, V position, Clock, Phase and White Level.
[H POSITION], [V POSITION] and [PHASE] are adjusted automatically when new timing is detected.
NOTE:
Depending on the display card or drivers used, the image may not be adjusted correctly.
In this case, please run [AUTO SETUP], or individually set [H POSITION], [V POSITION],
[CLOCK], and [PHASE].
When [AUTO ADJUST] is [ON], if the screen position shifts repeatedly, please change the setting
to [OFF].
Controls the horizontal position of the image within the display area of the LCD.
Press + button to move right. Press – button to move left.
Controls the vertical position of the image within the display area of the LCD.
Press + button to move up. Press – button to move down.
Press + button to expand the width of the image on the right of the screen.
Press – button to narrow the width of the image on the left of the screen.
Adjusts the visual "noise" in the image.
Adjusts the horizontal size of the image.
Adjusts the vertical size of the image.
When the monitor detects an HDR signal, you can select preferred gamma correction from [LOW],
[MIDDLE] or [HIGH].
Adjusts the crispness of the image. Press + or – button to adjust.
NOTE:
Depending on the combination of the input resolution and the [ASPECT] setting, this function may
not work.
Select the aspect ratio of the screen image.
NOTE:
•
If you change [H POS] and [V POS] settings with a reduced image, the image will not be
changed.
•
The [ASPECT] automatically changes to [FULL] when the [SCREEN SAVER] starts. When the
[SCREEN SAVER] stops, the [ASPECT] returns to its previous setting.
•
This function is not available when [MOTION] in [SCREEN SAVER] is active.
•
[ZOOM] is not available for an image with an input resolution of 4K.
Shows the aspect ratio as it is sent from the source.
Fills the entire screen.
Expands a 16:9 letterbox signal to fill the entire screen.
Shows the image in a 1 by 1 Pixel format. (If the input resolution is higher than the recommended
resolution, the image will be scaled down to fit the screen).
Expands/reduces the image.
NOTE:
The areas of the expanded image that are outside of the active screen area are not shown.
The reduced image may have some image degradation.
Maintains the aspect ratio while zooming.
Horizontal zoom value.
Vertical zoom value.
Horizontal position.
Vertical position.
English−75
Advertisement
Table of Contents
