Table of Contents
Advertisement
Daytime Running Lights — If Equipped
To activate the Daytime Running Lights (DRL), rotate the
end of the multifunction lever to the O symbol.
NOTE: The low beams and side/tail lights will not be on
with DRL.
The DRL function can be turned on or off through the
touchscreen. Refer to "Uconnect Settings" in "Multimedia"
for further information.
High Beams
With the low beams activated, push the multifunc-
tion lever forward (toward the front of the vehicle)
to turn on the high beams. The lever will remain forward in
a fixed position and the telltale will illuminate in the
instrument cluster display. Pull the multifunction lever
rearward (toward the rear of the vehicle) to turn off the
high beams.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the high beam headlights to turn on, and remain
on, until the lever is released.
GETTING TO KNOW YOUR VEHICLE 43
Parking Lights
To turn on the parking lights, remove the key or
turn the ignition to STOP (OFF/LOCK) position
and turn on the headlights.
NOTE: If the parking lights are left on and the key is in the
stop position with the door open, an audible chime will
sound and a message will show in the instrument cluster
display. The chime will stop as soon as the door is closed or
the lights are switched off.
Follow Me Home/Headlight Delay
When this feature is selected, the driver can choose to have
the headlights remain on for a preset period of time after
the engine is turned OFF.
Activation
Remove the key or turn the ignition to the STOP (OFF/
LOCK) position, and pull the multifunction lever toward
the steering wheel within two minutes. Each time the lever
is pulled, the activation of the lights will be extended by 30
seconds. The activation of the lights can be extended to a
maximum of 210 seconds.
3
Advertisement
Chapters
Table of Contents
