Installation; Safety Instructions; Setup - Asko DFI654B.AU Operating Instructions Manual

Table of Contents

Advertisement

*Remove locking nuts for an installed height of 820-821 mm.
**Door length.
It is important that you read through and follow the instructions and directions below. Conduct
installation and connection in accordance with the separate installation instructions.

Safety instructions

Connections to electricity, water and drainage must be performed by a qualified professional.
Always follow applicable regulations for water, drainage and electricity.
Take care during installation! Wear protective gloves! There must always be two people!
Before screwing the dishwasher into place, test the dishwasher by running the Rinse and hold
program. Check that the dishwasher fills with water and drains. Check also that none of the
connections leak.
WARNING!
Turn off the water supply when installing the dishwasher!
The plug must be disconnected or power to the socket turned off while the work is carried out!

Setup

The dimensions and connection information are included in the separate installation instructions.
Check that all dimensions and connections are correct before commencing the installation. Note
that the height of the exterior panel can be adjusted to match other fittings.
Make sure the area on which the dishwasher is to be installed is firm. Adjust the adjustable feet
so that the dishwasher is level. Tighten the lock nuts.
If the dishwasher is built-in the surrounding cabinetry must be resistant to any condensation
from the dishwasher.

Installation

[mm]
Nominal dimensions. Actual measurements may vary.
35

Advertisement

Table of Contents
loading

Table of Contents