Britax PINNACLE 90 User Manual page 24

Care and Maintenance
Cleaning the Buckle
If your child eats and drinks while in the child seat, you may need
to check the buckle periodically and rinse out any accumulated
debris or dried liquids.
Buckle Removal
Open the CLICKTIGHT.
1
* Locate the two slots in the
CLICKTIGHT cover.
* Squeeze the CLICKTIGHT
release levers.
Unhook the clips at the back
2
of the seat cover from the
child seat shell.
* Pull the belly pad over the
buckle retainer to remove.
Pull the seat cover and foam
3
forward and over the EZ-
Buckle belly pad.
Turn and pull the buckle
4
retainer through the slot in the
child seat shell.
* Pull the belly pad over the
buckle retainer to remove.
44
To Clean:
• THOROUGHLY RINSE the buckle using warm water.
• TEST THE BUCKLE by fastening and unfastening until a positive
click is heard after inserting each buckle tongue. If clicks are not
heard, repeat the cleaning procedure.
• TOWEL DRY
• DO NOT:
* Soak
* Lubricate
* Use solvents
* Use soap or household detergents
Buckle Replacement
IMPORTANT: Select the slot closest to, but not under the child.
Turn and push the buckle
1
retainer through the slot in the
child seat shell.
Pull the EZ buckle belly pad
2
through the corresponding
slot in the seat cover.
* Ensure that the buckle strap is
not twisted and that the button
faces out.
Place the seat cover and foam
3
back in their original positions
and attach the retaining clips.
Close the CLICKTIGHT.
4
* A click confirms the
CLICKTIGHT is secure.
Care and Maintenance
45