Additional Features; Programming The Remote Control - Polaroid TTM-2901L User Manual

ADDITIONAL FEATURES

Programming the Remote Control

1.Set the TV, DVD/VCR, SAT/CAB, AUX switch to the device you want to control
2.To program the remote control
1)Press and hold the SET key for over 3 seconds until the LED indicator on the remote control turns off. Release the key
and the LED will light again. The remote control is now in the PROGRAMMING mode.
2)Use the 0-9 keys to enter three-digit code number for your device. If the right code number was entered, the LED blinks
three times. If you enter a code not listed below, or you press any other keys than STANDBY and ENTER, the LED turns
off.
3)"TV": To control TV . "DVD/VCR": To control DVD, VCR, LD and CD. "SAT/CAB": To control satellite receiver
and cable box. "AUX": To control all the above appliances
3.To search codes
1)Press and hold the SET key for over 3 seconds until the LED indicator on the remote control turns off. Release the key
and the LED will light again. The remote control is now in the PROGRAMMING mode.
2)Press the STANDBY key and code search begins.
3)
Press
The remote control searches codes upwards or downwards. Each time you press the up or down
arrow key, the code number for the STANDBY key increases or decreases by 1; or the code
Up or down
number automatically increases or decreases by 1 per 3 seconds. Try each code separately until
arrow key
you find the one that works. If not after trying all the codes, LED blinks rapidly eight times and
search stops.
If the desired code number is found, press the ENTER key to confirm the current searched code
ENTER
number for your device. Then LED blinks rapidly three times to exit from search.
Other keys LED blinks rapidly eight times and search stops.
4)When the TV, DVD/VCR, SAT/CAB, AUX switch is set to the "AUX" position, the remote control can not search
code.
4.To check the current code number
1)Press and hold the SET key for over 3 seconds until the LED indicator on the remote control turns off. Release the
key and the LED will light again. The remote control is now in the PROGRAMMING mode.
2)Press the ENTER key.
3)You may read the code number according to the LED display status as follows.
Code Number
First-digit Second-digit
0 0
1 0
0 4
1 5
5.To use the REC key
The REC key functions only when it is pressed twice continuously.
Third-digit First-digit
0 Blinks rapidly once
6 Blinks once
3 Blinks rapidly once
0 Blinks once
Description
LED Display Status
Second-digit
Blinks rapidly once
Blinks rapidly once
Blinks four times
Blinks five times
14
Third-digit
Blinks rapidly once
Blinks six times
Blinks three times
Blinks rapidly once