Yamaha FJR1300AS 2017 Owner's Manual page 31

TIP
If traveling at speeds under 10 km/h (6
mi/h), "_ _._" will be displayed.
NOTICE
If there is a malfunction, "– –.–" will
be continuously displayed. Have a
Yamaha dealer check the vehicle.
Adjusting the windshield position
To move the windshield up, push
the " " side of the select switch. To
move the windshield down, push
the " " side of the select switch.
Setting mode
MENU
Grip Warmer
Maintenance
Time Trip
Unit
Display
Brightness
Clock
1. Setting mode display
TIP
 The transmission must be in neu-
tral and the vehicle must be
stopped to change settings in this
mode.
 Shifting the transmission into gear
and starting off, or turning the key
to "OFF", saves all settings made,
then exits the setting mode.
Push and hold the menu switch
"MENU" for 2 seconds to enter the set-
ting mode. To exit the setting mode
Instrument and control functions
and return to the normal display, push
and hold the menu switch "MENU"
again for at least 2 seconds.
ECA15474
1
3-17
Display
This function allows you to
set the low, middle, and
Grip Warmer
high settings to 10 tem-
perature levels.
This function allows you to
check and reset the "OIL"
oil change interval (dis-
Maintenance
tance traveled), and the
"FREE-1" and "FREE-2"
maintenance intervals.
This function allows you to
check and reset the
"TIME–2" and "TIME–3"
functions. These time trips
show the total elapsed
time that the key has been
in the "ON" position. When
the key is turned to "OFF",
Time Trip
the time trips stop count-
ing but are not reset. The
maximum time that can be
shown is 99:59.
When the time trips reach
99:59, they automatically
reset to 0:00 and continue
counting.
This function allows you to
switch the display units
between kilometers and
miles. When kilometers are
Unit
selected, the fuel con-
sumption units can be
switched between
"L/100km" and "km/L".
This function allows you to
change the items shown in
Display
3 information displays.
This function allows you to
adjust the brightness of
the multi-function meter
Brightness
unit panel to suit the out-
side lighting conditions.
This function allows you to
Clock
set the clock.
This function allows you to
reset all items, except the
All Reset
odometer and the clock.
Description
3