Mower Belt Maintenance; Inspecting The Belts; Replacing The Mower Belt - Toro TimeCutter SS 5060 Operator's Manual

Hide thumbs Also See for TimeCutter SS 5060:
Table of Contents

Advertisement

3
2
7
1
Figure 58
1. Mower deck
2. Grass deflector
3. Grass-deflector bracket
4. Rod
2. Slide the rod out of the short standoff, the spring, and
the grass deflector (Figure 58).
3. Remove the damaged or worn grass deflector.
4. Replace the grass deflector (Figure 58).
5. Slide the rod (straight end), through the
rear-grass-deflector bracket.
6. Place the spring on the rod, with the end wires down
and between the grass deflector brackets.
7. Slide rod through the second grass-deflector bracket
(Figure 58).
8. Insert the rod at the front of the grass deflector into
the short standoff on the deck.
9. Secure the rear end of the rod into the mower with a
nut (3/8 inch) as shown in Figure 58.
Important: The grass deflector must be spring
loaded and in the down position. Lift the deflector
up to test that it snaps to the full down position.
4
5
6
G005192
5. Spring
6. Nut (3/8 inch)
7. Short standoff

Mower Belt Maintenance

Inspecting the Belts

Service Interval: Every 25 hours—Check the belts for wear
or cracks.
Check the belts for cracks, frayed edges, burn marks, or any
other damage. Replace damaged belts.

Replacing the Mower Belt

Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks, and cracks are
signs of a worn mower belt. Replace the mower belt if any of
these conditions are evident.
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Set the height-of-cut at the lowest cutting position [38
mm (1-1/2 inches)].
4. Using a spring-removal tool, (Toro part no. 92-5771),
remove the idler spring from the deck hook to remove
tension on the idler pulley and roll the belt off the
pulleys (Figure 59 and Figure 60).
WARNING
The spring is under tension when installed
and can cause personal injury.
Be careful when removing the belt.
38

Advertisement

Table of Contents
loading

This manual is also suitable for:

74638

Table of Contents