Plustek SmartPhoto P60 User Manual page 21

Plustek p60: user guide
Hide thumbs Also See for SmartPhoto P60:
Table of Contents

Advertisement

Cause2:
The printer brightness setting is not set properly.
Solution 2:
Adjust the brightness in the printer. Some printers allow you to change
the brightness settings. Please consult your printer documentation.
Symptom:
The scanned image takes too long to be sent with an email
message.
Cause1:
The image was scanned at a high resolution or is physically large.
Solution1:
Scan at a lower resolution (DPI).
Cause 2:
The Internet might be congested.
Solution 2:
Try sending the message at a later time.
Symptom:
The image that I sent through email looks good in my computer but
it looks dark in the recipient computer.
Solution:
The Monitor gamma settings should be approximately the same in your
and the recipient computer.
Symptom:
A. -Disk is full- error is displayed when I click on the scan button.
Cause:
Your computer is running low in resources. Your computer hard disk
drive does not have enough space to process the image. This may be
because you are scanning at too high of a resolution.
Solution:
Obtain a larger hard disk or rescan at a lower resolution.
Symptom:
A -Disk I/O error- message is displayed.
Cause 1:
This error is caused if the hard disk drive does not have enough space
available to process the image.
Solution 1:
Make some space available in the hard disk drive by deleting any
programs or files that you do not need.
Symptom:
The error "Scanner not Found" that is displayed.
Cause 1:
The USB cables are not connected properly.
Solution 1:
Make sure that the cables are connected tightly and to the proper port.
Cause 2:
The USB cable might be too long.
Solution 2:
Please use the USB cable that comes with your scanner.
Symptom:
The document or photo has been inserted into the scanner but is
not fed through the scanner.
Cause 1:
The document or photo was not correctly inserted into the scanner.
Solution 1:
Make sure the document or photo is properly inserted into the page feed
of the scanner.
Solution 2:
The paper may be too think or too thick.
18

Advertisement

Table of Contents
loading

Table of Contents