Adjusting The Shift Pedal; Adjusting The Reverse Control Cable - Yamaha RAPTOR YFM700RF 2015 Service Manual

j. Tighten the bleed screw to specification.
Bleed screw
6 Nm (0.6 m·kg, 4.3 ft·lb)
k. Fill the brake fluid reservoir to the proper level
with the specified brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-19.
EWA13110
WARNING
After bleeding the hydraulic brake system,
check the brake operation.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS21370

ADJUSTING THE SHIFT PEDAL

1. Measure:
• Shift pedal height "a"
Out of specification → Adjust.
Shift pedal height
48 mm (1.89 in)
a
2. Adjust:
• Shift pedal height
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Loosen the bolt "1".
b. Remove the shift pedal "2".
c. Install the shift pedal at the correct height.
d. Tighten the bolt to specification.
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
1
2
Shift pedal bolt
16 Nm (1.6 m·kg, 11 ft·lb)
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS29240
ADJUSTING THE REVERSE CONTROL
CABLE
1. Check:
• Reverse knob free play "a"
Out of specification → Adjust.
Reverse knob free play
2.0–4.0 mm (0.08–0.16 in)
2. Adjust:
• Reverse knob free play
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Slide back the boots "1" and "2".
b. Loosen the locknut "3".
c. Turn the adjusting nut "4" until the reverse
control cable "5" is taut or the length "a" is 33
mm (1.30 in).
TIP
Be sure to hold the reverse shift lever "6" when
making this adjustment so that it does not move.
3-23
CHASSIS
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼