How To Take Off The Front Panel; Wiring Connection - Toshiba RAS-10S3KHS-EE Installation Manual

How to take off the Front panel

(1) Open the air inlet grille upward.
(2) Remove two screws of the front panel.
(3) Slightly open the lower part of the front panel then pull the upper part of
the front toward you to remove it from the rear plate.
Air inlet grille
2

Wiring Connection

How to connect the power cord
Wiring of the power cord can be carried out without removing the front
panel.
(1) Take off the air inlet grille.
(2) Remove the terminal cover and the cord clamp.
(3) Protrude power cord about 15 cm from the back body.
(4) Securely connect the Earth line to
line to L and Neutron line to N.
(5) Tighten fi rmly but not over 1.2 N·m (0.12 kgf·m).
(6) Put the power supply cord through the notch.
Power supply terminal
block (L, N, )
Cord clamp
Terminal cover
Screw
Stripping length of the power supply cord
10 mm
N
L
NOTE
• Use stranded wire only.
• Wire type : More than H07RN-F or 60245 IEC66 (1.5 mm
CAUTION
For the air conditioner with the power supply cord
• If the power supply cord is damaged, it must be replaced by the
manufacturer, the service agency, or another similarly qualifi ed person
in order to avoid hazard.
Front panel
1
3
fi rst then secure connect the Live
L N
Power supply cord
Screw
Earth line
40 mm
10 mm
30 mm
2 or more).
Taking out the power cord
• Put the power supply cord through
the notch.
How to connect the connecting cable
After connected the power cord completely.
(1) Protrude connecting cable about 20 cm from the back body.
(2) Securely connect the Earth line to
connecting cable to terminal 4, 3, 2 and 1.
(3) Tighten fi rmly but not over 1.2 N·m. (0.12 kgf·m).
(4) Secure the power cord and connecting cable with the cord clamp.
(5) Secure the terminal cover and air inlet grille on the Indoor or secure the
front panel, air inlet grille and then fi x its by screws in case front panel
take off.
(6) Make sure connect the same terminal number between Indoor and
Outdoor unit.
CAUTION
• Be sure to refer to the wiring system diagram labeled inside the front
panel.
• Check local electrical cords and also any specifi c wiring instructions or
limitations.
Connecting cable
Plastic wired
guide
Cord clamp
Terminal cover
Screw
Screw
NOTE
• Use stranded wire only.
• Wire type : More than H07RN-F or 60245 IEC66 (1.5 mm
How to install the air inlet grille on the indoor
unit
• When attaching the air inlet grille, the contrary of the removed operation is
performed.
4
fi rst then secure connect the
Connecting terminal
Plastic wired guide
block (1, 2, 3, 4,
Power supply terminal
block (L, N,
Power supply cord
Connecting cable cord
120 mm
10 mm
110 mm
10 mm
4
3
10 mm
90 mm
10 mm
100 mm
Stripping length of the connecting cable
Notch
)
)
Earth line
Earth line
2 or more).