Download Print this page

Intermatic RC Series Installation, Operation & Service Manual page 2

Three-channel radio transmitter

Advertisement

Linking Multiple Transmitters with a Receiver
Up to three different transmitters can control a receiver. Follow steps 1 through 5 of Linking an RC939 Transmitter
Button with the RC613 Receiver.
OPERATION
How to Use the Radio Transmitter
Once you setup the required links between the transmitter(s) and receiver(s), you are ready to use the transmitter. Press
the configured button on the transmitter to turn the connected device ON/OFF.
NOTE: The usable operation range for the transmitter is 100 feet.
The transmitter linking that was configured at Initial Setup can be revised as needed. Follow the applicable instructions
below to revise the transmitter/receiver linking.
Excluding a Transmitter Button Link from a Receiver
Follow this procedure to exclude a transmitter button from a receiver:
1. With a stylus or paper clip, press the button on the side of the transmitter until the red LED illuminates.
NOTE: See Figure 2 for location of the button and LED.
2. Momentarily press the configured ON/OFF button on the transmitter that you want to exclude from the receiver.
3. Momentarily press one of the other buttons on the transmitter. The red LED on the transmitter turns OFF.
4. Momentarily press the button you wanted to exclude to verify it no longer controls the receiver. The button is now
excluded.
Deleting All Links from a Receiver
To delete all links from a receiver, press and hold the Code-Set button for 20
seconds. All the codes are deleted from the receiver and all links between the
transmitter(s) and the receiver are deleted.
Changing the Transmitter Battery
Follow this procedure to remove or change the transmitter battery.
1. Insert a wide flat screwdriver into the slot on the side of the transmitter and
remove the cover.
2. Replace the CR2032 lithium coin type battery inside the transmitter.
NOTE: Make sure the new battery's + terminal is facing away from the circuit
board on the transmitter.
3. Snap the cover onto the transmitter.
If within the warranty period specified, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is
extended to the original household purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or
any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding
the cost of the product; (e) sealed lamps and/or lamp bulbs, LED's and batteries; (f) the finish on any portion of the product,such as surface and/or weathering, as this is considered normal wear
and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES,
SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF
MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS
THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased or (b) completing a warranty claim online at www.intermatic.com.
This warranty is made by: Intermatic Incorporated, Customer Service 7777 Winn Rd., Spring Grove, Illinois 60081-9698. For warranty service go to: http://www.Intermatic.com or call
815-675-7000.
LIMITED ONE-YEAR WARRANTY
INTERMATIC INCORPORATED
Spring Grove, IL 60081-9698
www.intermatic.com
Figure 4
Figure 5 Removing transmitter cover
158--01960

Advertisement

loading

This manual is also suitable for:

Rc939