Intermatic RC613L Installation, Operation & Service Manual

http://waterheatertimer.org/Intermatic-trippers-and-parts.html#remote-receiver
RC SERIES
REMOTE-CONTROLS
SINGLE-CHANNEL RADIO RECEIVERS
Model: RC613, RC613L Switching Module
For indoor and outdoor use, suitable for Pool/Spa equipment control
ELECTRICAL RATINGS: 15 A Resistive, 1200 W Tungsten, Motor Load: 1 HP @ 120 VAC, 60 Hz
THIS DEVICE COMPLIES WITH FCC RULES PART 15. Operation of this device is subject to the following two conditions
1) This device may not cause harmful interference. 2) This device must accept any interference that may be received,
including interference that may cause undesired operation. FCC rules prohibit adjustments to or modification of receiver
and transmitter circuitry except for replacing the remote-control battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Risk of Fire or Electric Shock
WARNING
• Installation and/or wiring must be in accordance with national and local electrical code.
• Use COPPER conductors ONLY.
• The control panel to be a minimum of 3 M. (in Canada) or 5 ft. (in USA) from the inside wall of the pool, spa, or pond, unless separated from
the body of water by a fence, wall or other permanent barrier that will make the unit inaccessible to persons in the water.
• Do NOT exceed maximum current carrying capacity.
• This enclosure does not provide grounding between conduit connections. When metallic conduit is used, you must also install grounding type
bushings and jumper wire, in accordance with the (NEC) National Electrical Code requirements.
• This control should not be connected to any equipment which would cause bodily injury or property damage should it be activated
unexpectedly.
• Disconnect power at circuit breaker(s) or disconnect switch(es) before installing or servicing.
• Test GROUND FAULT protection regularly. If it fails to reset, DO NOT USE THE POOL or SPA! Contact a qualified service technician.
WARNING Risk of Injury
• Do NOT permit children to operate the Control Unit or use the Pool/Spa unless they are closely supervised at all times.
These Modular Radio Receivers are one-half of a two-part remote-control
system. They operate as ordinary ON/OFF switches but they also respond
to the signals of a hand-held transmitter - the other half of the system. The
modules are designed for indoor or outdoor use, and can handle a variety
of residential switching applications. By the push of a button on the face of
the transmitter, the user is able to turn ON/OFF the connected load (lights,
pump, etc.) from a remote location*, safely and conveniently. In addition, a
single RC939 transmitter can operate up to three Receivers and is able to
"teach" each Module a different code. (Transmitters are sold separately).
Model RC613 Receiver Module comes with its own manual ON/OFF
button and it is intended to be installed at the location of the load. The
connected load may be turned ON/OFF using the hand-held transmitter
or turned ON/OFF by pushing the red button on the face of the Receiver.
Model RC613L Receiver Module is the same as RC613 except that it
comes with extra-long (36 in.) leads.
* The open field range is approximately 100 feet, but depends on many
factors like the age of the battery, proximity of large metal objects, the
location of the receiver and environmental conditions at the time of
transmission.
GENERAL INFORMATION
INSTALLATION
OPERATION &
SERVICE MANUAL