Terminal Modules; Spring Clamp Terminal Module - HP VXI E1476A User's Manual And Programming Manual

Terminal Modules

Spring Clamp
Terminal Module
Figure 1-6. HP E1476A Standard Spring Clamp-type Terminal Module
20 HP E1476A Multiplexer Setup
The HP E1476A 64-Channel, 3-Wire Multiplexer Module is comprised of a
multiplexer switch card and a spring clamp type Terminal Module. The
screwless terminals utilize a spring clamp terminal for connecting solid or
stranded wire. Connection is made with a simple push of a three-pronged
insertion tool (HP part number 8710-2127), which is shipped with the
Multiplexer. If the spring clamp type Terminal Module is not desired, a
crimp-and-insert Terminal Module (Option A3E) and an interface to rack
mount terminal panel (Option A3F) is available. See "Figure 1-12. HP
E1476A Multiplexer Pin-out" on page 31 for the Multiplexer's connector
pin-out which mates to the Terminal Module.
Figure 1-6 shows the HP E1476A's spring clamp standard Terminal Module
connectors and associated channel numbers.
Note
Refer to Page 28 and 29 before attempting to wire the Terminal Module.
Chapter 1