Planar EX2 Quick Reference Manual page 3

1
Installing the EX2 Display Controller
Turn your computer off. Leave the power cord plugged into the grounded outlet.
Remove any existing graphics card and its driver from your computer system
before you install the EX2 controller and driver. Also disable any onboard
graphics capability on the motherboard.
To install the controller
1 Turn off your computer and all peripherals.
Disconnect all cables from your computer.
2 Remove the computer cover.
3 Remove any existing graphics card and
video signal cable, if necessary.
4 Remove the blank bracket from the available
AGP slot.
5 Insert the EX2 controller into the AGP slot,
align the connector pins, and press the
board down until it is firmly seated.
6 Use the power extension cable to connect the
EX2 controller to the computer's hard drive
power connector. See page 4.
7 Secure the mounting bracket.
8 Reattach the computer cover and the peripherals.
Open AGP slot
Blank bracket
EX2 controller
installed
3