Table of Contents
Advertisement
Dometic 8700 Series MasterFlush Toilet
6
Operation
6.1
Toilet system start-up
1 . Turn on water supply to toilet .
2 . Press "Flush" switch (fig .
and run for about six seconds to clear bowl . It will take about five seconds to refill bowl .
3 . Toss several sheets of toilet paper into bowl and repeat
cycle . The bowl should completely clear .
6.2.1
Normal toilet operation -
Dometic touchpad or other wall switch
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (fig .
is achieved . (Water flow will shut off automatically if switch
is pressed too long to avoid overflow .) More water is usually
added only when flushing solids .
FLUSHING TOILET
Press "Flush" switch (fig .
macerator pump that siphons water and waste from the bowl, macer-
ates, and propels the effluent through the discharge line to the holding
tank .
Caution – Do Not Flush Foreign Objects!
Flush only water, bodily wastes and rapid-dissolving toilet
tissue . Do not flush wet wipes, sanitary napkins, condoms,
diapers, paper cups, cotton swabs, food, hair or liquids
such as oils or solvents as clogging or damage to the toilet
or toilet system may occur .
Note
Make sure all guests understand toilet operation before use .
6.2.2
Changing flush modes
Dometic 8700 series MasterFlush toilets offer two flush settings to help manage water consumption:
Normal flush – Uses 0 .85 gal . (3 .2 liters) per flush . Adds water to bowl after every flush .
Dry Bowl flush – Uses 0 .45 gal . (1 .7 liters) per flush . Does not add water to bowl after flush .
To change from Normal to Dry Bowl flush setting, press "Flush" switch for about five seconds . When
"Power On" light (fig .
Dry Bowl setting . Change mode to Normal flush by following the same procedure .
6.2.3
Indicator lights
"POWER ON" INDICATOR
On the Dometic flush switch panel, a steady green "Power On" light (fig .
electrical power to the toilet is activated . A momentary flashing green light indicates when flush
mode is changing .
"FULL TANK" INDICATOR
The Dometic flush switch panel includes a red "Full Tank" light (fig .
tank is full (if connected to a tank monitoring system) and should be pumped out . When the red light is
illuminated, electrical power to the toilet automatically shuts off to prevent overfill of the holding tank .
4
2) once . After nine seconds of water flow, macerator pump will start
4
1) until desired water level
4
2), then release it . This activates a powerful
4
3) begins flashing, release "Flush" switch . Flush mode has been changed to
4
1
3
4
3) indicates when
4
4) to indicate when the holding
Operation
2
4
7
Advertisement
Table of Contents
